The compact design of the low-profile buckets allows for a high bulk density of the product on the belt.

 High-quality American steel with deep hot-dip galvanization of the surface.

 The high precision in manufacturing sections simplifies on-site assembly.

 The UHMWPE shaft seals protect against moisture and dust ingress. Felt versions are also available.

 Removable inspection hatches on both sides of the upper cover facilitate quick installation and maintenance of the belt and buckets.

 The bearing units in the leg-mounted housing do not transfer heat and load to the walls of the housing, unlike flange bearings.

 Meets NFPA requirements.

 The wear surfaces in the head and boot are covered with lining. Available linings include polyurethane, abrasion-resistant (AR) steel, and ceramic tiles.

 Loading hoppers are available with 1/4 inch (6.4 mm) wear-resistant steel lining on models from BE36 to BE48, with this option available for models from BE18 to BE30.

 A gravity tensioning station is offered with drums in diameters of 18, 24, 30, 36, 42, and 48 inches (457, 610, 762, 914, 1067, and 1219 mm).

 A wide range of other options is available: maintenance platforms, stairs, safety frames, and explosion vents.

 Optional stainless steel support legs for the boot are ideal for working in pits and other aggressive environments.

 Fully welded flange connections provide additional reliability.

 The inspection and maintenance windows have sealing gaskets.

The performance of BROCK elevators ranges from 37 tons/hour to 1,600 tons/hour.