SPEED SENSORS 

The French company STIF is a world-renowned manufacturer of elevator components. Such companies as BUHLER, CIMBRIA, ANDRITZ, CROCUS, SKANDIA ELEVATOR, PETKUS, ZUTHER, SHENK PROCESS REDLER and many others equip their equipment with STIF products. The production base is located in the west of France and is equipped with modern equipment that allows you to produce up to 600 buckets per hour. START-AP is the exclusive representative of STIF in Ukraine. 

Dustproof STIF speed sensors are designed for safety and efficient elevator operation. The speed sensor is installed on a known drum and allows you to judge the degree of slippage of the noria tape and, if the specified value is exceeded, gives a signal about the occurrence of an emergency situation.

 VIGIRO IP26 – CRCI91250T: Ue 10 … 36V Cable 2m – NOT ATEX

The VIGIRO® IP26 speed/rotation sensor is designed to monitor the rotational speed of a shaft. The VIGIRO® IP26 includes a pulse meter that registers the frequency of nominal pulses. It is intended for installation on bucket elevators and chain conveyors.

 The VIGIRO® IP26 speed/rotation sensor is mounted on the shaft using an M12 bolt for standard configurations or an M10 bolt upon request.

 As an option, it can be mounted using the EAZYFIX magnetic holder, allowing for quick commissioning of the sensor and avoiding the need for drilling for bolts.

 Protective housing made of polycarbonate

 Connecting cable 2m (3 wires)

 Rotating shaft M12 for standard configuration (M10 upon request) for mounting to the shaft

 Metal propeller with 2 supports under a transparent cover

 The speed/rotation sensor VIGIRO® IP26 can be adjusted, accommodating a rotation frequency from 0.5 to 500 revolutions per minute, which corresponds to 1 to 1000 pulses per minute

GIRO L IP18 – CRLI91261T: Ue 10 … 36V DC Cable 2m – NOT ATEX
Standard configuration: 2 pulses per revolution

 The GIRO L IP18 inductive speed/rotation sensor is designed to monitor the rotational speed of a shaft. It is used to detect dangerous decreases in the shaft's rotational speed. This sensor is intended for installation on bucket elevators, chain conveyors, mixers, rotary fittings, and conveyor belts

 The sensor is mounted on the shaft using an M8 bolt or with an EAZYFIX M8 magnetic holder, which allows for quick commissioning of the sensor and avoids the need for drilling for bolts (note: the EAZYFIX magnetic holder cannot be installed on stainless steel shafts)

Почніть з клієнтом - з'ясуйте, чого вони хочуть і дайте їм це.